Please Note: You are viewing the unstyled version of POLARIS Laboratories. Either your browser does not support CSS (Cascading Style Sheets) or it is disabled. As a result, much of this website will not look the way it was intended, although all of its contents will be accessible to you. For more information, visit our Browser Support page.

Skip to Primary Site Navigation, Secondary Site Navigation, Content, Company Address

Home > Publications Directory > Technical Bulletins > Effectively Monitor Soot Levels in EGR Engines

Effectively Monitor Soot Levels in EGR Engines

The growing popularity of EGR (exhaust gas recirculation) engines has raised the question, “What is an acceptable level of soot?” and if I can expect a higher level of soot in an EGR engine, “Then why not raise the oil analysis alarm limit?”

Soot is soot. Knowing that a particular engine design creates and retains more of it doesn't make higher levels acceptable. Alarm limits should remain the same — maintenance practices should change. Utilizing enhanced additive packages with more efficient dispersants and closely monitoring the condition of the oil between oil changes to determine optimum drain intervals is the better solution.

Fuel in a diesel engine is injected during the compression stroke. The high pressure ignites the fuel immediately allowing it no time to properly mix with air. Combustion is incomplete and soot is created. Engine designs of the past expelled most of the soot created by inefficient fuel combustion through the exhaust, but EGR engines re-circulate exhaust gases back into the cylinder at a lower temperature to reduce NOx emission. Retarding ignition timing and reducing the amount of oxygen in the cylinder produces less NOx but inhibits combustion and creates excess soot.

If not adequately dispersed within the oil, soot particles begin to agglomerate, or gather into clusters increasing viscosity and allowing deposits to form on metal surfaces. Thick, sooty oil can plug filters and increase operating temperatures which can cause lubrication starvation and ultimately, metal on metal contact. The soot then becomes a harsh abrasive that accelerates wear in cylinder liners, rings, piston skirts, journal bearings and valve trains.

Print this Technical Bulletin (PDF - 88K)


Top

News

New Fuel Test Packages Will Reduce Fleet Expenses and Downtime

POLARIS has developed an extensive range of fuel troubleshooting test packages that can confirm the quality of bulk deliveries and resolve what might be causing costly repairs and fleet downtime. Fleet managers spend more money on fuel than any other operating expense, so this is an area of great importance.

Read More

Sign Up for eNewsletters


POLARIS Named Fluid Analysis Provider for Industry's Largest International Oil Distributor Group

The Association of Independent Oil Distributors (AIOD) announced this month its launch of the Purus Assurance System, a fluid analysis program administered by POLARIS Laboratories™ to support AIOD's newest brand, Purus.

Read More


Training

  • Salt Lake City
    Cooling Systems Maintenance
    September 20, 2010

  • Salt Lake City
    Practicing Oil Analysis
    September 21-22, 2010

  • Edmonton, AB
    Cooling Systems Maintenance
    October 26, 2010

View complete schedule and registration information


Tradeshows & Conferences

  • Oil Sands Show
    Ft. McMurry, Alberta
    September 15-17, 2010

  • Lloydminster Heavy Oil Show
    Lloydminster, SK
    September 15-16, 2010

View all tradeshows